A slider guide oil X method?
① Power off the laser machine, hexagonal wrench to be used within the lens slider removed (to protect the lens). Removed after the show four hexagonal lenses, respectively, removed from the belt when the slider and, in a fixed linear rail under the nail fold Yiyi, (careful not to touch knock Guides) (not the slider removed ) then place reverse grasp the rail, exposed parts of the slider and rail connections, if the slider Lack of oil will see at this time the ball is illuminated, when the oil's lubricating oil needle out of that Using wooden toothpicks to the oil-tim to crack, followed by filling with rolling slider, so that each ball as far as possible lubricants touch
② oil so that the End slider back and forth rolling about in the guide, then be loaded onto rail at first, paying attention not to allow a fixed rail, fitted to a fixed pin and maintain the level of the belt in a fixed fixed and slider, and then installed lens, dimming the way you finished X direction.
Second regular cleaning of the components:
① mirror: a total of three. 2 open, 1 sealed cadmium open a period of time for each lens (based on usage) (generally about a month, medical alcohol use paper or cotton dip mirror Brush try)
② Cooling Fan: Machine work 3 - 4 months or so after the flip open, then the laser tube and the fan has a lot of dust down the need for Brush try, clean and then immediately after loading.
Third, when the bearing oil.
① cotton fibers on the surface dust wipe bearings with needle needle inhaling the oil with the needle slowly into the bearings, rotating slowly in the oil bearing when you can.
Fourth, the adjustment of take-off and landing platform.
Because X is the level of rail, so the volume of steel foot platform can be, is to turn off the machine, the four corners of the platform were basing revenue plans on spending-foot steel vertical distance above the platform is fixed with screws, nails the following is used to adjust.
Five fonts are carved in the appearance of ghosting.
① hands on the machine next to the elastic belt and feel it, look at the X-axis gear wear and listen to X axis of the issue of rail movement, unpleasant voice.
② can begin by belts, gears were removed, clean up will be a good slider and then the machine loaded lubricants, and appropriate adjustments in the engraving text, if there is not the same phenomenon can be if there is, on the open sslaser the paper, adjusting the parameters.
Before and after six hours or so large-format sculpture intensity varies significantly
① First of all, to see whether the plane with the lens to maintain the level of the optical path in the look right, if the issue resolved in a timely manner, if not, take a look at the local voltage stability unstable at room temperature to see how many degrees will the general low-temperature laser cooling good, if not contact clearance and manufacturers. |
